How to use

SPHERULITE How to Use

How to use

For detailed instructions see application instructions and use a wet film gauge to ensure minimum and maximum wet film thickness is achieved.

Before use, the contents of the container should be thoroughly mixed at medium speed until a homogeneous consistency is obtained.


Before use, the surface must be primed with a deeply penetrating primer (in case of building materials), and in the case of application on steel, thoroughly remove the signs of rust mechanically and degrease the surface.


Sferolite can be then applied to the cleaned surface with a brush, a roller or a paint gun. It is allowed to add water in an amount not exceeding 70ml per 1 litre of the preparation.

The minimum wet film thickness is 0.8mm, the maximum is 1.2mm [wet film].


Do not apply in wet or frosty conditions (apply at an air temperature of +5 to + 35 ̊С), protect against rainfall until it is completely dry and avoid applying when rainfall is predicted within 24 hours. The drying time of the applied layer with a layer thickness of up to 1mm at a temperature of + 20 ̊С and a relative humidity of up to 60% - 3 hours. 

Spray Application

  • Preparation for application: tools for spray painting should be thoroughly rinsed with clean water. They must be completely clean;
  • The surface should be clean from dirt, primed / degreased;
  • Apply with a spray gun to obtain a minimum thickness of 0.8mm and a maximum of 1.2mm [wet film];
  • When applying with an air spray gun, the mass should be diluted with water up to 10% of the total mass of the material;
  • The application should be carried out in circular movements and subsequent layers should be applied after the previous layer has dried and cured completely. The film applied by spraying will be more homogeneous. 


Personal Protection/ Health & Safety 

During application, it is recommended to use a protective mask, protective gloves (prevention of e.g. an allergic reaction), protective glasses (in particular when applying with a pressure gun), painting suit to avoid stains on shoes and clothes, hearing protection, headphones when using a compressor during spray painting. 


Precautions


Observe the recommendations given in the safety data sheet. This data sheet does not contain information on the safety of the product. Before using the product, read the safety data sheet and the labels on the packaging in order to obtain information about the safe use and health and physical hazards. Dispose of in accordance with applicable legislation. Keep out of the reach of children. Notes for the client: The above information is accurate and to the best of our knowledge, based on reliable research and practical experience. The specified properties are provided for guidance only and do not constitute guaranteed product properties. The customer should test the product for specific applications to be sure that it has the expected properties and provides the required operational performance. 


APPLICATION SURFACES

CONCRETE

CERAMICS

PLASTERBOARD

WOOD

METAL

PLASTIC

GLASS

BRICKS & BLOCKS

Share by: